S
Sea Bass
I have encountered a weird problem.
System Spec:
Windows 10
Intel I9-9980 HK
16 GB Ram
RTX 2080 16GB MAX-Q
ADATA SX8200PNP 2TB SSD
KXG50PNV2T04 2TB SSD
Two M.2 SSDs, A is the boot drive, has no problems at all, about 2800 MB/s read.
B is the other nonboot drive, when windows first start, within the first few seconds, CrystalDiskMark shows normal read speed, about 2700 MB/s. Then if I wait a minute or so, test it again, read speed max out at 200-400 MB/s. In task manager, it shows near 100% active time. Write is about 500 MB/s.
BIOS is set on ACHI mode. Options are either ACHI or Raid.
Both SSDs have a Read speed rating of around 2.8 GB/s. TLC memory.
Please help, thank you!
Continue reading...
System Spec:
Windows 10
Intel I9-9980 HK
16 GB Ram
RTX 2080 16GB MAX-Q
ADATA SX8200PNP 2TB SSD
KXG50PNV2T04 2TB SSD
Two M.2 SSDs, A is the boot drive, has no problems at all, about 2800 MB/s read.
B is the other nonboot drive, when windows first start, within the first few seconds, CrystalDiskMark shows normal read speed, about 2700 MB/s. Then if I wait a minute or so, test it again, read speed max out at 200-400 MB/s. In task manager, it shows near 100% active time. Write is about 500 MB/s.
BIOS is set on ACHI mode. Options are either ACHI or Raid.
Both SSDs have a Read speed rating of around 2.8 GB/s. TLC memory.
Please help, thank you!
Continue reading...