Windows 7 Check cable connection! error

  • Thread starter Thread starter DAVID VELEZ BUSTAMANTE
  • Start date Start date
D

DAVID VELEZ BUSTAMANTE

Hi, I have a lenovo g400 with windows 8 64bit. Yesterday I turned it on in the morning and I got the following message: Check cable connection! PXE-M0F: Exiting Intel PXE ROM. No bootable device -- insert boot disk and press any key I looked on the internet and it said that there were 3 common ways this happened 1. the hard drive was disconnected or connected wrong. 2. the bios was out of configuration 3. the hard disk was faulty. I entered the bios and after two changes of settings, the computer started, I turned it off and then I turned it on again and the problem did not occur, I tu

Continue reading...
 
You must log in or register to reply here.

Similar threads

M
Windows 11 Intel UNDI ERROR
Replies
0
Views
6
Mary Ann Sy
M
R
Windows 11 how can I fix a bios loop stuck in legacy boot?
Replies
0
Views
14
Reece GFSP
R
A
Windows 10 My computer don’t run proper way due to hard disk issue. When I attached cable in hard disk slot, windows don’t open. It shows only loading. What's th
Replies
0
Views
5
Auntor Saha
A
A
Windows 10 UNEXPECTED_KERNEL_MODE_TRAP caused by NTFS, request minidump analysis
Replies
0
Views
5
A user hate windows
A
R
Windows 10 Internet connection problem
Replies
0
Views
1
RWhit_588
R
Back
Top