Windows 10 Feature update to Windows 10, version 20H2 failed 0xc1900101

  • Thread starter Thread starter MuhammadAbdul Raheem
  • Start date Start date
M

MuhammadAbdul Raheem

Whenever I update, After 1st restart, it goes upto 25-28%, then it restarts 2nd time, then it fails at 48% with a generic prompt message.After that it goes in recorvery mode to undo all the changes done during installation.After that my system boots up, showing Feature update to Windows 10, version 20H2 failed 0xc1900101 in my update history.- I've updated my BIOS- Secure boot is enabled- I've tried updating using Windows Update Agent as well, but it has same result. This time error was: "Windows Setup could not configure Windows to run on this computer's hardware".Specs: HP Omen, Intel 6700HQ

Continue reading...
 
You must log in or register to reply here.

Similar threads

A
Windows 10 0xC1900101 - 0x30018: Windows Update Failing After 48%
Replies
0
Views
3
Aditya Khati
A
D
Windows 10 Feature update to Windows 10, version 22H2 - Error 0x80070002
Replies
0
Views
7
DaxFM
D
X
Windows 10 Feature update to Windows 10, version 22H2 fails with error 0x8007001f (22/7/2024)
Replies
0
Views
7
xgiro
X
G
Windows 10 Feature update to Windows 10, version 22H2 failed to install 0xc1900101
Replies
0
Views
13
Gio Falco1
G
D
Windows 10 Windows Update unable to install feature update, DISM can't restore health or clean components
Replies
0
Views
3
Davtrap21
D
Back
Top