Windows 10 How to escape special characters in SC Config command

  • Thread starter Thread starter Román Díez Gea
  • Start date Start date
R

Román Díez Gea

Hi Everyone,I'm trying to log on in one service with a specific user and password so I run this command in command line:SC config ServiceName type= "own" obj= "user" Password= "password"Supposedly everything is ok because the message I get is:[SC] ChangeServiceConfig SUCCESSBut When I try to run the service again once I change the configuration in command line I get this:SC start ServiceName[SC] StartService FAILED 1069: The service did not start due to a logon failure.I think the problem is the password which contains special characters like %\"@: so I don't know how can I escape in order th

Continue reading...
 
You must log in or register to reply here.

Similar threads

A
Windows 11 Ignore special characters input to use shortcut in VSCode
Replies
0
Views
11
Aditya Kotkar
A
J
Windows 10 How do I use command prompt to erase information and change logins?
Replies
0
Views
14
Jessica Tatum
J
J
Windows 10 error 1053: The service did not respond to the start or control request in a timely fashion
Replies
0
Views
11
Julio Magaia
J
M
Windows 10 My laptop is stuck in the auto repair loop, how can i access troubleshoot - system restore or command prompt? If i cant login to account- it keeps ask
Replies
0
Views
2
Maria Theresa B Montalbo
M
V
Windows 10 Windows 10 - I can’t log in even though the password is correct and I am connected to the internet
Replies
0
Views
5
vtechdir
V
Back
Top