Windows 7 I am trying to install windows 7 sp1 and after the 2nd part of the installation begins,seconds later my PC crashes.

  • Thread starter Thread starter Doruk Kaya
  • Start date Start date
D

Doruk Kaya

I was trying to install windows 7 on my HP Pavilion g6(g6-2300) laptop.When the installation procceeded to the 2nd part of the installation (where you dont need to boot off of the usb) it crashed with an error code of:STOP: 0x0000007E (0xFFFFFFFFC0000005,0x[16 zeros],0xFFFFF880033247E8,0xFFFFF88003324050)I tried going into the safe mode environment (with networking,with command promt,last known good config..)but none of them worked.i tried disabling Legacy Support in BIOS but that displayed the windows logo with a red rectangle on the top of the screen, stretching from start to end. Here ar

Continue reading...
 
You must log in or register to reply here.

Similar threads

C
Windows 11 Upgraded pc, and ssd and now I get two bluescreens just trying to install windows
Replies
0
Views
7
Curtis Harweger
C
D
Windows 10 Why does the Windows Update KB5040427 fail to install and I get Error message 0x80070026 each time
Replies
0
Views
5
DMcClo
D
T
Windows 10 I am fully locked out of my pc after trying to update to 20h2
Replies
0
Views
26
Tristan Gielen
T
C
Windows 10 How do I get the Windows 7 installation wizard to detect my mouse and keyboard.
Replies
0
Views
14
Chris the Wookie Bingley
C
Y
Windows 7 I have a Windows 7 PC and would like to install Windows 10 or 11 without deleting my data
Replies
0
Views
20
YY242023
Y
Back
Top