J
Jim_16103
Hi,
I just upgrade myself a new rig for light gaming here is the spec:
- Generic B75 board (non EUFI bios - AMI) -X-Star brand
- i5 3570
- 8gb ram 1333 mhz
- 512 gb SSD
- rx 580 4gb
I installed all the driver for the board (LAN, Sound and Chipset) and the VGA driver from AMD.
When I install Windows 10, everything went well.
Now the problem only when I started to run games using either Epic Games or Steam (from fresh start up), it will BSOD on average 2-4 times before it is stable enough to run games.
The BSOD have various stop code:
UNEXPECTED_KERNEL_MODE_TRAP -> driver: bedaisy.sys
KERNEL_SECURITY_CHECK_FAILURE -> ntoskrnl.exe (nt+0x3F5780)
MEMORY_MANAGEMENT -> ntoskrnl.exe nt+0x3F5780)
REFERENCE_BY_POINTER -> ntoskrnl.exe (nt+0x3F5780)
PAGE_FAULT_IN_NONPAGED_AREA -> amdkmdag.sys (0xFFFFF8043D1DDDC2)
I have read that I may have an outdated driver, but I don't know which one is the one responsible (especially for the ntoskrnl.exe)
I have tried to get some tools to get my driver updated (like DriveEasy by Easeware), however the problem persists, even worse, the BSOD takes 1 or 2 more times from the previous (ie BSOD 4-6 times before being stable).
Checked MemTest86, no problem for my RAM
Well at this point, I am open to any suggestions, tips or solution on the problem.
Thanks beforehand.
Regards.
Continue reading...
I just upgrade myself a new rig for light gaming here is the spec:
- Generic B75 board (non EUFI bios - AMI) -X-Star brand
- i5 3570
- 8gb ram 1333 mhz
- 512 gb SSD
- rx 580 4gb
I installed all the driver for the board (LAN, Sound and Chipset) and the VGA driver from AMD.
When I install Windows 10, everything went well.
Now the problem only when I started to run games using either Epic Games or Steam (from fresh start up), it will BSOD on average 2-4 times before it is stable enough to run games.
The BSOD have various stop code:
UNEXPECTED_KERNEL_MODE_TRAP -> driver: bedaisy.sys
KERNEL_SECURITY_CHECK_FAILURE -> ntoskrnl.exe (nt+0x3F5780)
MEMORY_MANAGEMENT -> ntoskrnl.exe nt+0x3F5780)
REFERENCE_BY_POINTER -> ntoskrnl.exe (nt+0x3F5780)
PAGE_FAULT_IN_NONPAGED_AREA -> amdkmdag.sys (0xFFFFF8043D1DDDC2)
I have read that I may have an outdated driver, but I don't know which one is the one responsible (especially for the ntoskrnl.exe)
I have tried to get some tools to get my driver updated (like DriveEasy by Easeware), however the problem persists, even worse, the BSOD takes 1 or 2 more times from the previous (ie BSOD 4-6 times before being stable).
Checked MemTest86, no problem for my RAM
Well at this point, I am open to any suggestions, tips or solution on the problem.
Thanks beforehand.
Regards.
Continue reading...