Windows 10 System does not boot after cloning SSD to NVME

  • Thread starter Thread starter Saku Erholtz
  • Start date Start date
S

Saku Erholtz

I cloned my SSD to my NVME SSD succesfully, but when I am trying to boot from the NVME it will display two different kinds of error messages depending on if I am booting with Legacy or UEFI. If I am booting with Legacy or UEFI with CSM, it will display a black screen that says:"Boot Device Not Found Please install an operating system on your hard disk.Hard disk - (3F0)F2 System DiagnosticsFor more information, please visit: www.hp.com/go/techcenter/startup"If I am booting with UEFI without CSM it will say:"No bootable image found, notebook will shutdown". This screen is white with a blue OK bu

Continue reading...
 
You must log in or register to reply here.

Similar threads

R
Windows 10 NVME M2 SSD disappears from Windows when trying to install games, replaced SSD, and same issue
Replies
0
Views
4
Ruben Underwood-Aguilar
R
Y
Windows 11 I just installed a brand new Crucial P3 Plus PCle 4.0 NVMe M.2 SSD on my computer and I can't seem to get out of the MSI Click Bios 5, what do I do?
Replies
0
Views
6
Yahiko Leyva
Y
S
Windows 10 Cloned hdd windows 10 to ssd , it works fine for weeks till i delete old drive
Replies
0
Views
9
supa yoda
S
C
Windows 10 Cloning Windows 10 Home to new SSD hard drive?
Replies
0
Views
10
Cursor Arrows
C
G
Windows 10 Can't boot Windows 10 with AMD motherboard
Replies
0
Views
24
Guy1985
G
Back
Top